|
#1
|
|||
|
|||
Only Backing Up Single Folder to Network Share
Using Ver 2.1.4. We have 4 Macs in design dept and their current projects are kept in folder named "Work-"person's name" (e.g., Work-Amy). I want to backup just the Work folders to a shared network folder on an NTFS drive but NOT their entire drives. I know how to configure backup over a network but even when I select Backup-user files I don't seem to have any options to choose a specfic folder to backup. Any suggestions?
|
#2
|
||||
|
||||
We can't copy directly to a network drive, gilley. You'd end up copying to images in that folder, which doesn't sound like what you want.
__________________
--Dave Nanian |
#3
|
|||
|
|||
Thanks for responding but I'm a little confused now. I am looking at the SD User's Guide and it specifically describes in chapter "Backing up over a network" how to backup using "Disk Image" to an NTFS network volume. Perhaps my understanding of "disk image" is incorrect. All I want to do is backup the contents of folder Work-Name every night so that projects/data can be recovered incase of an emergency or a goof-up.
|
#4
|
||||
|
||||
That's fine, then: just recognize that the files will be inside a disk image 'container'.
If you'll drop me an email to support I'll provide you with the steps to isolate a single folder in a backup.
__________________
--Dave Nanian |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Backing Up to Network Share - AAAAAAAAAHHHHHHHHH !!!!! | snpower | General | 14 | 11-29-2009 02:27 PM |
SD clone fails when the source is a .dmg on a read-only network share? | Robo | General | 5 | 08-09-2009 11:19 AM |
Single folder | BrennanBones | General | 1 | 06-15-2009 02:35 AM |
Hangs while backing up to network mounted sparse image | acronce | General | 9 | 09-11-2008 01:25 PM |
Difficulty backing up to a SMB network volume | CGremlin | General | 1 | 10-04-2007 09:45 AM |