|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Backed up to sparse image on Airdisk, but now can't select it again
I followed the instructions for creating a sparse image and sucessfully backed up to an Airdisk. However, when I launch SD now I can't figure out how to access the Airdisk again. The instructions say SD should mount it automatically, but nothing happens for me.
|
#2
|
||||
|
||||
Is the image file listed as the destination?
__________________
--Dave Nanian |
#3
|
|||
|
|||
No, there is nothing showing as the destination - and the destination drop down list only shows the local disks on the computer.
|
#4
|
||||
|
||||
Right, so you'll choose "Disk Image..." in the destination pop-up, then select the image in the standard file panel (even if it's grayed out)....
__________________
--Dave Nanian |
#5
|
|||
|
|||
OK, I got it now. I had to drill down through several destination layers before seeing the destination image I needed, but I got there in the end.
I was just a bit confused, because the manual says SD would mount the destination automatically. |
#6
|
||||
|
||||
It should once it's been saved...
__________________
--Dave Nanian |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SD not unmounting sparse image volumes | acronce | General | 1 | 09-14-2008 11:22 AM |
Hangs while backing up to network mounted sparse image | acronce | General | 9 | 09-11-2008 01:25 PM |
network sparse image question | subrama6 | General | 2 | 02-21-2008 11:35 AM |
sparse image creep revisited | jotaro | General | 3 | 09-20-2007 08:20 PM |
Sparse image from aborted DMG backup? | Winston | General | 9 | 10-22-2005 12:28 PM |