#3
|
|||
|
|||
boots to old (original) disk
Dave,
Thanks for the reply. I tried holding cmd-option-v and get the boot messages displayed but the machine boots to the old (original) disk. I was able to try to boot off the new (cloned) disk by booting with option depressed and then selecting the new disk. I'm not sure I know a good way to get around this. One thing I can think of is to switch the disk controller cables around and make the new disk the master disk, then boot with cmd-option-v held. Any commments before I proceed? Bob |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Incomplete Boot of Clone - Blue Screen | Argent | General | 13 | 11-15-2005 02:10 PM |
Problem getting apps to run on clone volume | ChetA | General | 3 | 09-06-2005 02:19 PM |
Safety Clone or Clone | na goodman | General | 3 | 08-10-2005 07:14 AM |
Upgrading a safety clone to tiger | 00afro | General | 12 | 07-09-2005 11:53 AM |
Applying system update to safety clone | na goodman | General | 3 | 02-20-2005 03:41 PM |