View Single Post
  #1  
Old 03-22-2013, 03:45 PM
camner camner is offline
Registered User
 
Join Date: Apr 2004
Posts: 160
recovering from i/o error

Yesterday I cloned one external drive to another external, and just about the same time that SD finished up, there was a spontaneous unmount of the target volume. This has happened to me before (occasionally) and I was successfully able to redo the cloning (using Erase and copy, not Smart Copy).

I then repartitioned the 1st drive and started to clone back. Consistently (I've tried cloning back several times) there is an i/o error which I'm pretty sure is on the drive being read (that is, the TARGET of the initial clone yesterday that is the SOURCE of the "cloning back" process). I say "pretty sure" because I found a reference in the Console logs to an i/o error on "disk1s2" and using disk utility I could tell which volume was "disk1". [By the way, is there any easier way to find the i/o error than looking through lots of log entries in the 'all' log entry...such as a particular log to look at?]

I've swapped the drives physically (I have two Voyager docks) to try to eliminate the possibility that there is a cable or physical problem with the dock and the problem persisted in the other dock.

What I'm going to try to do is to use the Finder to copy a smaller number of folders at a time rather than SD to try to clone the entire disk. Fortunately, it isn't a volume that contains a system!

So, a couple of questions:

1. Is my proposed approach a reasonable one? Can I count on the Finder copy being reliable if I don't get a read error?

2. Once I've gotten this read error, should I presume that the drive is toast, or is there a way to check the drive (and perhaps remap the bad sectors, if that's what it is)? It's not a new drive, and if it makes more sense to trash it, I'm certainly open to that!

Thanks!
Reply With Quote