sparseimage vs dmg
When cloning, SD! created a .dmg file. What is the difference between an .dmg file and a .sparseimage file, and when does SD! create one vs. another?
|
Well, a .sparseimage is a file that can be mounted like any other disk, and will 'grow' based on the amount of data stored in it. So, a 30GB .sparseimage, when empty, may only be a few hundred K. As you place more data into it, it gets larger, until it reaches the maximum size set when it was created.
A .dmg is another kind of disk image. It's of a fixed size, and can be either read-only or read-write. Page 20 of the manual goes into some detail about what SuperDuper! does when it directly creates an image -- that always results in a DMG, with a .sparseimage as an intermediate step. I recommend reading that page for additional ifnormation. However, as described in this post, you can use a sparse image directly to store backups in a "single file". Hope that makes it clearer! |
All times are GMT -4. The time now is 11:22 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.